Tank material

         Q235A carbon steel from WISCO

         End plate material

         Q235A carbon steel from WISCO

         Rated work Pressure

         0.2Mpa

         Manhole Cover

         Set

         500mm manhole cover,   set

         Outlet discharge Pipe

         2 unit,6m

         Inlet hole

           500mm inlet hole

         Discharge hole

         2 unit discharge hole

         Accessories

         Set

         A. One set of spare tire including a carrier, one tool box

         B. Ladder: In left and rear position, width>250

         C. Walkway: Width>1500mm

         D.Two fire hydrant

         Paint

          As required;

         Heating and insulation system

         Insulating layer

         1. Tank containing keep warm by insulation layer

         2. Insulation layer composed of: 50mm rock wool and carbon steel cold plate covered,  it can prevent the heat losing.

         Heating system

         1.Use Burner heater 24 hours continuous heating at back of the tanker

         2.One  Italian BALTUR diesel oil burner

         Capacity: 14*104Kcal/h, brand-new

         3. One general-purpose diesel generator

         4.According to continuous diesel burning to keep warm  

         (Diesel consumption:150kg/24hours)

         Note: It’s not necessary to adopt 24 hours continuous burning, you just only need begin to heat ahead of 4-5 hours while approach the destination site.

         It will save oil consumption and cost for you